Flooring Supervisor

Sweep, scrape, sand, or chip dirt and irregularities to clean base surfaces, correcting imperfections that may show through the covering; Cut flooring material to fit around obstructions;Inspect surface to be covered to ensure that it is firm and dry; Trim excess covering materials, tack edges, and join sections of covering material to form tight joint; Form a smoothfoundation by stapling plywood or Masonite over the floor or by brushing waterproof compound onto surface and filling cracks with plaster, putty, or grout to seal pores; Measure and markguidelines on surfaces or foundations, using chalk lines and dividers; Cut covering and foundation materials, according to blueprints and sketches; Roll and press sheet wall and floorcovering into cement base to smooth and finish surface, using hand roller; Apply adhesive cement to floor or wall material to join and adhere foundation material; Determine traffic areasand decide location of seams; Lay out, position, and apply shock-absorbing, sound-deadening, or decorative coverings to floors, walls, and cabinets, following guidelines to keep coursesstraight and create designs; Remove excess cement to clean finished surface.